Residential Concord
The older residential pockets of Concord feature bungalows and backsplits from the 1960s and 1970s, often with cast-iron stacks, copper supply and clay or cast-iron laterals. Kitchens and baths here have usually been redone; the hidden parts, especially the drain under the slab and the main shut-off, are often original. Newer townhome developments near Highway 7 have modern PEX and PVC.
Common issues
- Cast-iron drain lines with scale and rust
- Clay laterals with roots or offsets
- Original gate valves at the main
- Basement bathrooms tied into old drains
- Townhouse water heaters in tight closets
Older bungalows
Backsplits put plumbing at several levels, and the lowest level drain often sits close to the sewer depth. A floor drain that backs up is a common call. We clear the line, then check whether a camera inspection or backwater valve makes sense.
Cast-iron drains crack along the bottom over time. If your basement floor drain gurgles and smells, ask about a camera inspection.
Typical services
Concord calls include main line clearing, camera inspections and repiping of older copper.
Bungalows with basement apartments
Plenty of Concord bungalows have a lower-level unit with its own kitchen and bathroom, added years after the house was built. Those fixtures often tie into the original floor drain line or a short branch with poor slope, and grease from the second kitchen joins grease from the first. When a basement sink backs up into a shower, that shared line is usually the reason. We clear it, check the vent arrangement, and suggest a cleanout where access is poor so the next clearing is simpler.
Near the rail lines and industrial areas
Residential streets close to industrial Concord are built on the same heavy clay as the rest of Vaughan. Frost heave and settlement can open joints in older laterals, so a camera look is worth doing if backups repeat.
Our basement walk-through in Concord
- Main shut-off. We find it, turn it, and tell you if the wheel handle or ball valve still seals.
- Water heater. Read the date off the rating plate, look for rust at the fittings and test the relief valve.
- Floor drain and cleanout. Check the trap holds water and the cleanout cap comes off.
- Sump pit. Fill-test the pump and see where the discharge lands outside.
- Exposed supply. Note copper, PEX, poly-B or galvanized, and any green or white crust at the joints.
